We handle attic insulation in Eringate and the rest of M9C, which takes in Bloordale Gardens, Old Burnhamthorpe and Markland Wood. Our crew is about 4 km away. We look at what's already up in your attic and tell you straight which parts to keep, which to fix and which to add to.

Vallengrove Park's 1961 bungalows

Vallengrove Park was built in 1961 between Wellesworth and Highway 27. The houses are plain brick bungalows: three bedrooms, one bath and a garage, on lots about fifty feet wide. In a bungalow the attic covers the whole house, so the attic floor is most of the ceiling you're heating. If the layer up there is thin or patchy, every room below feels it, the front rooms as much as the back bedroom.

So the attic floor is the first thing we check in a Vallengrove Park house. Dry insulation that's only a little thin stays, and we build depth on top of it with blown-in insulation spread evenly between and over the joists. Wet insulation, or insulation mice have got into, comes out before anything new goes in. Our page on whether to remove old attic insulation before adding new goes through that call in more detail. And if your basement has a bare rim joist, spray foam insulation along the rim closes off the cold band where the framing sits on the foundation.

Markland Wood, finished by 1967

Building in Markland Wood started in 1960, after the Conservation Authority set the high-water marks following Hurricane Hazel. Most of the single-family houses were done by 1967, and tract housing went up at the north end of Thicket Road in 1971-1972.

Insulation from back then may still be the original layer, or someone may have topped it up since. You can't tell from the hallway. We go up through the hatch, read the depth against the joists and look for an older layer under a newer one, and whether that bottom layer is dry. Then we tell you what you've got. If a later top-up is sound, a Markland Wood attic may need very little. If it's only the original layer, it may need a full top-up. And if the exterior walls turn out to be empty, wall insulation dense-packed through small drill holes fills the cavities without opening up the walls.

Keep, fix or add in a 1960s attic

Dry original insulation stays. It still slows heat on its way out, and hauling away material that's doing its job makes no sense, so we top it up instead. Damp or rodent-soiled insulation comes out. It has stopped insulating, and it holds moisture against the ceiling drywall. Attic insulation removal clears it back to the ceiling before new material goes down.

Air leaks get sealed before any depth goes on. Warm air from the rooms below rises through gaps around plumbing stacks and along the top plates of interior walls, and loose insulation laid over those gaps barely slows it. Sealing them is worth doing first, because that's what lets attic insulation do its job. Frost or staining on the underside of the roof deck, or a bathroom fan duct that ends in the attic, has a cause the right trade needs to fix before we insulate. We'll point it out and wait until it's sorted.

If your attic is dry, sealed and already deep, we'll tell you so and leave it alone. Our rebates and cost page covers how rebates fit around the job.

Deane Park, Islington and Applewood

Deane Park, Islington and Applewood are the closest areas we serve to Eringate, and each has its own page: Deane Park, Islington and Applewood. The job in each is the same keep, fix or add call, one attic at a time.

Local details for Eringate

FAQ

Insulation questions from Eringate

Yes, as long as the original insulation is dry and free of mouse droppings, we blow new insulation over it. The old layer still does some work, so we leave it in place. Any wet or soiled patches come out first, and we seal the air leaks underneath before the top-up goes on.

Yes. Markland Wood is part of the M9C area we cover, along with Eringate and Bloordale Gardens. Most of the houses there were finished by 1967, so we check whether your attic still has its original insulation or a later top-up, then tell you whether to keep it, fix it or add to it.

The hatch stays where it is and still opens. We keep the new insulation clear of the opening and fix insulation to the top of the hatch cover so it matches the floor around it. Blown-in insulation is loose, and without that edge it would spill into the hallway every time you lift the lid.

Get a quote

Request an insulation visit in Eringate

Call (437) 563-1473 or send the form. Tell us what you've noticed in the house, like a cold room, frost in the attic or a drafty floor. We'll look at the attic and give you a written list and a quote.

Call Text Quote