We do attic insulation in Old Mill, about 8 km from us. This page covers M8Y: Old Mill South, King's Mill Park, Sunnylea, Humber Bay, Mimico NE and The Queensway East. We start with what is already in your attic and walls, then tell you what to keep, what to fix and what to add.

Built before and after the war

Most houses in Old Mill are single-family detached homes from the years before and after the Second World War. The land was laid out for housing after 1900, and building carried on through the years either side of the war.

So the attic in a house like that may hold layers from different times. There might be a thin first layer between the joists, with a batt or loose fill laid over it later. That is fine on its own. What we care about is whether every layer is dry, and whether warm air from the rooms below is getting through.

Our crew opens the hatch and looks at the joists, the top plates and the underside of the roof deck. If the insulation is dry and only a little thin, it stays. We blow a top-up over it and staple depth markers to the joists, so you can check the level yourself later.

Veterans houses on the Queensway

In 1946 a development of veterans houses for returning servicemen went up at The Queensway and Royal York, and many single-storey homes were built along The Queensway. The Queensway-Humber Bay community today is mostly single-family homes and low-rise apartment buildings.

A single-storey house has one attic over every room, so the attic floor is the whole lid. A thin patch over the back bedroom means a cold back bedroom. Watch the baffles at the soffit vents along both long sides too. Bury the eaves under a top-up and you cut off the air the attic needs.

Empty outside walls on a single-storey house can be filled without gutting the rooms. We drill a hole into each wall cavity, blow in dense-pack until the bay is full and firm, and plug the hole. Our wall insulation page goes through the method in detail. If a wall is already full, we leave it alone.

What to fix first in an older house

Wet or soiled insulation goes first. Matted batts, a dark stain on the roof deck, frost on the roofing nails in January, droppings from mice or squirrels: any of these means the attic floor gets cleared before anything new goes in. A pest-control company handles the animals, the right trade fixes a roof leak or a bathroom fan duct that ends in the attic, and then our crew does the attic insulation removal.

Next come the air leaks at the ceiling. Warm, damp air from the rooms rises through gaps around light boxes and the plumbing stack and takes moisture up into the attic. We seal those gaps from above before adding depth. Skip that and the new layer just ends up filtering that air.

Then depth. With the floor dry and the leaks sealed, a blown-in top-up brings your attic insulation up evenly across the joists. Walls come last, and only the empty ones. Spray foam earns its place on a bare rim joist in the basement, where one layer seals and insulates the pocket between the joists and the sill.

Our quote lists each piece of work separately.

The Kingsway, Islington and Mimico

We do the same attic and wall work in The Kingsway and Islington, the served areas closest to Old Mill. Mimico is the other neighbour. Part of it sits inside M8Y, so the attic gets the same keep, fix or add look on either side of that line.

Local details for Old Mill

About Old Mill: Old Mill, ON on Wikipedia ยท Old Mill on Google Maps

FAQ

Insulation questions from Old Mill

Yes. A single-storey veterans house can take a blown-in top-up across its one attic, and if the outside walls are empty they can be dense-packed. We check what is there first, since dry insulation that is only a little thin stays put. Anything wet or soiled comes out before new material goes in.

No. Adding or replacing insulation is on the City of Toronto's list of work that does not need a building permit. The Zoning Bylaw still applies to the property, though. If the job turns up something beyond insulation, like roof or framing work, the trade doing that work handles its own rules.

Yes, both are inside M8Y, the area this page covers. Our crew does attic, wall and rim joist insulation on houses in Sunnylea and Humber Bay alike. Every job starts the same way, with a look in the attic to sort out what stays, what gets fixed and what gets added.

Get a quote

Request an insulation visit in Old Mill

Call (437) 563-1473 or send the form. Tell us what you've noticed in the house, like a cold room, frost in the attic or a drafty floor. We'll look at the attic and give you a written list and a quote.

Call Text Quote