Attic insulation removal in Mississauga means we pull out old, wet or rodent-damaged insulation before replacing it. It is for homeowners whose attic has had a roof leak or animals living in it, and for anyone planning a top-up over a layer that is damp or dirty. Insulation that is dry and clean, only thin, usually stays and gets topped up.

When old insulation has to come out

Old insulation has to come out when it is wet or soiled. When it is dry and clean, it can stay. We make that keep, fix or add call before any attic insulation removal. Mississauga attics with a sound but thin layer get new insulation on top, and attics with a damaged layer get cleared first.

Wet insulation after a roof leak or condensation

Wet insulation stops insulating and holds moisture against the ceiling drywall and the roof deck. A roof leak causes it, and so does condensation, when warm house air reaches the cold underside of the roof. Frost or dark staining on the roof deck is the sign to look for. The leak gets fixed first, by a roofer, not by us. A bathroom fan duct that ends in the attic instead of outside does the same damage, and we point it out so the right trade can reroute it. Once the source is dealt with, the wet layer comes out.

Droppings, nests and urine

Rodent damaged insulation is the other clear case for removal. Mice and squirrels tunnel through loose fill, leave droppings and urine in it, and build nests against the warm ceiling. That insulation cannot be cleaned where it sits, so it comes out down to the bare attic floor.

A matted layer under a planned top-up

Some attics have an old layer that has been crushed, stepped on or packed down over the years. If that layer is also damp or dirty, blowing new insulation over it just buries the problem. In that case we take it out first, and our page on whether to remove old attic insulation before adding new walks through that call in more detail.

Dry, clean and thin: leave it

Dry, clean insulation that is only thin stays where it is. It still does its job, and a top-up over it is the sensible fix. Pulling out good insulation only adds mess and cost, so we will tell you to leave it. That is the same call Prime Insulation Contractors Mississauga makes on any house: keep what still works, fix what is wrong, add what is missing.

Animals out first

The animals have to be gone before we start. A pest-control company deals with them and with how they got into the attic. That part is not our work.

Clearing insulation while mice or squirrels are still living up there just hands them a clean floor to rebuild on. So the order is fixed: the pest-control company finishes, the activity stops, and then our crew takes out the soiled insulation, with the droppings and nests going out with it.

How the old insulation comes out

Old insulation removal runs from your front door to the bare attic floor, and each step is set up to keep the dust and debris out of your living space. Here is what happens on the day.

  • A covered path goes down from the door to the attic hatch, so nothing gets tracked across your floors or carpet.
  • A hose from an industrial vacuum runs up through the house to the attic, with the vacuum unit itself kept outside.
  • Our crew pulls the old insulation through the hose into removal bags, which are closed up and taken away.
  • The loose insulation gets cleared from between the joists until the drywall and top plates are bare. Mould on the wood, if there is any, goes to a mould remediation specialist before we go further.
  • Air sealing goes onto the bare ceiling while it is easy to reach: gaps around light boxes, plumbing stacks, wiring holes and along the top plates.
  • New insulation is blown in afterwards, with depth markers set out across the attic so you can see the level it reaches. Our page on blown-in top-ups explains that part.

Spray foam removal

Our crew can take out spray foam too. Foam bonds to whatever it was sprayed on, so it gets cut and scraped back from the joists, rafters or rim joist rather than vacuumed. The pieces are bagged and taken away like any other old insulation.

If it looks like vermiculite

Vermiculite looks like small, light pebbles, grey-brown or gold, often with a slight shine. It pours like gravel and settles between the joists.

Some vermiculite insulation may contain asbestos, Health Canada advises, and the best way to minimize the risk is not to disturb it at all. So vermiculite is where we put the tools down. If we come across it, the job stops right there and nobody touches it. We recommend you have a qualified lab or abatement firm test it before any work goes ahead.

We do not sample it, test it, vacuum it or remove it, and we do not arrange the test. Taking vermiculite out is a licensed abatement firm's job, not ours. Our page on vermiculite in the attic explains what happens before removal.

Plazas and light industrial units

We also do insulation removal in plazas and light industrial units around Dixie Road and nearby Etobicoke. The rules are the same there: the leak or the animals get dealt with first, and then we remove old, wet or rodent-damaged insulation. If vermiculite turns up in a unit, it stays where it is.

More on Attic Insulation Removal

FAQ

Common questions about attic insulation removal

The cost depends on the attic's area, how deep the old layer is, what is in it, how easy the attic is to get into and what goes back in afterwards. A layer full of droppings or soaked from a roof leak takes more care than a dry one. We look at the attic and then give you a quote for removal and for the new insulation.

The old insulation leaves your property in removal bags that our crew fills straight from the industrial vacuum hose. The bags are closed up at the truck and taken away with us. Nothing is left in your garage or driveway.

Yes, our crew removes spray foam insulation. Because the foam sticks to the wood, we cut it and scrape it back by hand instead of vacuuming it. Once the surface is clear, it can be insulated again.

No, thin insulation that is dry and clean stays in place. It still works, so we top it up with blown-in insulation instead of paying to remove it. Removal is for insulation that is wet, soiled by animals or matted onto a damp or dirty layer.

No, the animals have to be gone first. A pest-control company handles the animals and how they got in, and once the activity has stopped our crew removes the soiled insulation. New insulation over an attic that is still occupied would just get soiled again.

Get a quote

Get an attic insulation quote in Mississauga

Call (437) 563-1473 or send the form. Tell us what you've noticed in the house, like a cold room, frost in the attic or a drafty floor. We'll look at the attic and give you a written list and a quote.

Call Text Quote